How to Use the TP-ERA Extended Ruler Attachment

Simple instruction for installing knobs on a drawer front using the TP-ERA Extended Ruler Attachment

1. Use the Extended Ruler when installing hardware on multiple drawers with the same dimensions
2. Set each ruler at the 5” mark to extend the length of ruler to 22”
3. Measure drawer width to find center
4. Set the Sliding End Stop to half of the drawer width
5. Place hardware (measure as needed) to find position you like; mark hole location with pencil (We are centering on width and height)
6. Measure mark from step 5, set Large Stop to measurement, and tighten (Our drawer height is 6” so we set our Large Stop at 3”)

7. For knobs: drill through center bushing

For handles: measure hardware and tighten Sliding Drill Guides to match hardware measurement then drill

8. ALTERNATE CONFIG – If your handle pattern interferes with Double Bracket, move bracket below t-square and align each ruler at the 2” mark as pictured above
×
×

Cart

As a thank you for subscribing we're giving you 10% off your next order, use this code at checkout in the next 14 days:

Welcome10

Days
Hours
Minutes
Buy for $49.00 more and get free shipping