Cabinet Drawer Handle Installation
Simple instruction for installing a handle on a cabinet drawer using the Cabinet Hardware Jig ORIGINAL
*Use this method if you do not have the Rapid Center Extension (TP-CHJ-RC)
1. Place hardware (measure as needed) to find position you like. We are centering handle on width and height
2. Measure hole centers. Adjust and tighten Sliding Drill Guides. Cover unused bushing with tape to prevent accidental drilling
3. Measure drawer width to find center
4. Use half of measurement from step 3 to mark center on top of drawer
5. Measure height of drawer front
6. Set Large Stop to half of measurement from step 5 if centering
7. Line up notch on Large Stop with mark from step 4, then drill
